1968 Camaro Vintage Air Installation. Our install deleted the compressor and mounting bracket since it was already in place thanks to a vintage air front runner install we previously covered. Posted on november 7, 2018, 9:35 pm, by ryan zwicker, under installation feature, tech video.
Surefit kits install easily and utilize most of the factory sheet metal and body features and are engineered as vehicle specific complete systems. Attach cables to evaporator and control panel as shown on figure 9, page 12. Hello john, because our systems were designed to add a/c to a car that never had it and the car was built differently depending on whether or not it had factory a/c, there would be a few key differences when installing in a car that came with factory a/c.
Replacement Of Components, Vintage Air Recommends That The Right Fender Be Removed, And The Inner Panel Lowered (See Figure 1, Below).
Attach cables to evaporator and control panel as shown on pg. After installing cables and verifying full opening and closing of evaporator door, heat/defrost door. Sounds like more trouble than the vintage air unit.
Attach Cables To Evaporator And Control Panel As Shown On Figure 9, Page 12.
Remove oem heater wiring/vacuum harness molded grommet (discard) (see figure 1, below). The 1968 camaro perfect fit smart series™ air conditioning system is designed specifically to bolt into your 1968 camaro with minimum modification to your vehicle. The 1967 camaro used for the 48 hour build wasn't equipped from the factory with ac.
Not Just Aftermarket Air Conditioning!
Our surefit kits are designed to place the evaporator case and air duct hoses behind. Surefit kits install easily and utilize most of the factory sheet metal and body features and are engineered as vehicle specific complete systems. 1967/68 camaro & firebird factory evaporator testing:
Free Shipping When Your Order Includes This Part.
It is a lot of work but if you follow the directions to the t it is very doable. If you have a friend that is handy you can do it. Posted on november 7, 2018, 9:35 pm, by ryan zwicker, under installation feature, tech video.
Here Is The Reply From Tim At Classic.
Our install deleted the compressor and mounting bracket since it was already in place thanks to a vintage air front runner install we previously covered. After installing cables and full opening and closing of evaporator door, heat,'defrost door. Hello john, because our systems were designed to add a/c to a car that never had it and the car was built differently depending on whether or not it had factory a/c, there would be a few key differences when installing in a car that came with factory a/c.
